iPV4S 120W TC Mod by Pioneer4you
i won this mod from BuildEVape.com through a contest on facebook
they currently have a new contest going on
the IPV4s to me is an awesome mod and very easy to use
this mod has some weight to it but not too much
it has a sexy sleek design it will run from 10 to 120W
on TC from 212 to 572
it has a Heavy Duty Aluminum body
the battery cover is easy to come off but after a while has a tendency to stretch from taking it on and off to change batteries
the IPV4s uses 2 18650 batteries the batteries i have in i brought from Badabingvape.com HERE i can go 24 hrs on a set of those
Reverse Polarity Protection
Battery Low Voltage Protection
the display shows lots of features
it clearly states watts volts and what ohms my coil is running at along with battery status
10 to 120W Output Wattage
pressing the fire button 5 times fast will bring up the menu screen where you can change from watts to Joules which is temperature control
the display shows what Joules I'm running at the temperature i have it set at the ohm of coil and volts and battery level
5 to 50 Joules (Ni200 Nickel)
5 to 100 Joules (Ti Titanium)
The menu settings are System on, Power mode, Exit on,
under power mode if you use button at the bottom you can change to Joules then you get more options
0.1 to 3.0 Ohm Minimum Kanthal Built Atomizer Resistance
0.12 to 1.0 Ohm Minimum Ni200 Nickel and Ti Titanium Built Atomizer Resistance
the fire button is the largest button at the top
pressing this 5 times fast brings up the menu options
these buttons are used to increase or decrease watts / TC they are also used to change or select different options in the menu
if no tank is attached when you press the fire button nothing happens except the display shows Check Atomizer
Low Resistance Protection
Low Voltage Protection
Temperature Overheat Protection
Output Short Circuit Protection
I would recommend this to all vapers both novice and experienced
